In learning for the CCNA Test and planning to earn this precious certification, you may well be tempted to invest minor time researching static routing and head ideal for the greater exciting dynamic routing protocols like RIP, EIGRP, and OSPF. This is certainly an understandable oversight, but nonetheless a miscalculation. Static routing isn't complicated, nevertheless it’s a very important matter over the CCNA exam along with a worthwhile skill for serious-globe networking.
To develop static routes with a Cisco router, you employ the ip route command accompanied by the place community, community mask, and both the next-hop IP tackle or maybe the regional exit interface. It’s critical to keep that final component in your mind – you’re possibly configuring the IP handle of your downstream router, or perhaps the interface to the regional router that will serve as the exit 먹튀검증 interface.
Permit’s say your neighborhood router contains a serial0 interface using an IP handle of 200.one.one.1/30, and the downstream router that will be the subsequent hop will receive packets on its serial1 interface using an IP handle of 200.1.1.2/thirty. The static route are going to be for packets destined for your 172.ten.one.0 community. Possibly of the next ip route statements could well be proper.
R1(config)#ip route 172.10.1.0 255.255.255.0 200.one.1.2 (next-hop IP handle)
OR
R1(config)#ip route 172.10.one.0 255.255.255.0 serial0 ( area exit interface)
You may as well produce a static route that matches only one location. This is the host route, and has 255.255.255.255 for your mask. If the above static routes should only be accustomed to ship packets to 172.10.one.1., the next commands would do the job.
R1(config)#ip route 172.ten.1.1 255.255.255.255 two hundred.one.one.two (future-hop IP handle)
R1(config)#ip route 172.ten.one.1 255.255.255.255 serial0 ( community exit interface)
Lastly, a default static route serves to be a gateway of past resort. If there isn't any matches to get a destination inside the routing desk, the default route will probably be utilized. Default routes use all zeroes for both of those the desired destination and mask, https://www.washingtonpost.com/newssearch/?query=토토사이트 and once more a upcoming-hop IP handle or regional exit interface can be used.
R1(config)#ip route 0.0.0.0 0.0.0.0 two hundred.one.one.2 (subsequent-hop IP deal with)
R1(config)#ip route 0.0.0.0 0.0.0.0 serial0 ( neighborhood exit interface)
IP route statements appear simple adequate, but the details concerning the upcoming-hop IP handle, the area exit interface, default static routes, and also the syntax of the command are crucial for success on CCNA Examination working day and in the true environment.